- Servo drawing vector code serial#
- Servo drawing vector code software#
- Servo drawing vector code code#
Servo drawing vector code code#
Subprograms and Macros Engraving compatible (short vector g code no problem).
Servo drawing vector code serial#
The same port also supports TCP and UDP protocols for sending commands from Applied Motion’s proprietary serial command language (SCL).Īll SSM23IP models are CE Conformant and ODVA Conformant for EtherNet/IP. and the codes of the National Electrical Manufacturers Association. Centroid Allin1DC CNC Control board kit for use with DC servo motors. The SSM23IP-2EG comes with a fast 10/100 MBit Ethernet port for programming and EtherNet/IP communications. The analog input accepts 0-5 VDC signals and can be used for velocity and position control. The digital output can be connected to PLC inputs, counters, lights, relays, or other devices. The digital inputs accept signals of 5-24 VDC and can be used for connecting pulse & direction signals, end-of-travel limit switches, jog switches, quadrature encoder signals, PLC outputs, sensors, or many other signal types.
Servo drawing vector code software#
All SSM23 units are setup, configured and tuned using Applied Motion’s Step-Servo Quick Tuner software with built in Q Programmer.Įach SSM23IP integrated StepSERVO comes with 3 digital inputs, 1 digital output, and 1 analog input. Q programs are created using Applied Motion’s Q Programmer™ software, which provides powerful commands for motion, I/O, conditional processing, multi-tasking, math functions, and more. This integrated StepSERVO can be operated in several different control modes, including Streaming Command mode using either SCL, Pulse & Direction mode, and Velocity mode, plus it has the ability to run a Q program stored in non-volatile memory. All drive+motor features can be accessed over EtherNet/IP, including more than 100 commands and 130 registers for controlling motion, I/O, configuration, polling, math, register manipulation, and Q programming. With EtherNet/IP users can control, configure and query the drive using an open, standards-based, industrial Ethernet connection at speeds up to 100 MBits/sec. The SSM23IP-2EG integrated StepSERVO incorporates EtherNet/IP network communications, the widely used industrial protocol for manufacturing automation applications. StepSERVO integrated motors can be applied in systems where a traditional stepper motor would not be capable of achieving the high accuracy required. Boost torque of 25-50% higher than rated holding torque increases the limits of acceleration, leading to faster cycle times. The result is a highly customizable all-in-one motion control solution that operates quietly and efficiently, requiring only the minimum amount of current to maintain commanded position and velocity. StepSERVO technology combines the high torque capabilities of a step motor with the closed loop dynamic control of a servo system. See Related and Recommended Products below for compatible 24 and 48 volt DC power supplies.
Power to the drive, located at the rear of the motor, must be supplied by an external DC supply.
The SSM23IP-2EG integrated StepSERVO™ is a drive+motor unit, fusing a NEMA 23 step motor and a servo drive into a single device.